If it has a pre-measured post that should extend into the door and lock body, you may have to cut it to the proper length based on the thickness of the door. This is where the exterior handle will be installed in the next step.īefore installing the exterior handle, locate the interior side hardware. With the other hand, slide the square spindle from the interior side of the storm door in through the lock so that it sticks out of the exterior side as well. Position the hardware on the front of the door and hold it in place with one hand. Then take the mortise lock, with the key hold toward the outside, and slide the post from the exterior side of the storm door into the proper space in the lock body. Screw them all the way in, but be sure not to overtighten them as this can cause the plate to bend and damage the lock or create unnecessary friction when opening and closing the storm door. Using the proper screwdriver, fix the cover plate in place on the storm door with screws at the top and bottom of the plate. Then, slide the lock body into the hole where the old one had been with the latch facing outward. Take the new lock body and look for the label indicating the side that should face upward. Once you have your new mortise lock and hardware in hand, it’s time to finally replace that old storm door lock and hardware. Plus, you will find a nearly unlimited number of options online or at a doors and window store where they can order the style, color, metal and size required for your storm door. You can find a limited selection of door locks and handles at your local hardware store. Select a new mortise latch and hardware that you want to replace the old set with for your storm door. Then, for the exterior part of the door where the handle hardware was, wiping with paper towel and a mild spray detergent should be sufficient. To clean out buildup from the hole where the mortise was, use a vacuum. Now would be a good time to clean the door to remove any dust or dirt that has collected around the old hardware and inside the door where the new lock will be installed. If the lock body doesn’t pop out easily, you can also insert a screwdriver into the hole in the door and into the key mechanism to help pry it out. Remove the lock body from the storm door by pulling down from the top of the casing with your finger or the tip of a flat head screwdriver. Keep a box or bowl nearby to place all the pieces and screws in as the hardware comes apart. You may need to jiggle them slightly to pull them completely apart. Gently pull the interior and exterior handles and cover plate until they come free. Continue on and remove the other screws keeping the handle hardware attached to the door. Then use a Phillips screwdriver or power screwdriver to take out the screws on the cover plate. Step 2: Remove the screws and cover plates Using an Allen key, loosen the set screw and remove the interior door handle. You should measure and even take pictures of it to ensure that you purchase the right type when you go to the store and select the replacement. Steps for Replacing the Lock and Hardware on a Storm Doorīefore you get started replacing the storm door hardware, take a careful look at your current hardware.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |